DSP STARTER KIT FOR THE TMS320C6713 HARDWARE FEATURES:
	Texas Instrument’s TMS320C6713 DSP operating at 225 Mhz.
	Embedded USBJTAG controller with plug and play drivers, USB cable included
	TLV320AIC codec
	2M x 32 on board SDRAM
	512K bytes of on board Flash ROM
	3 Expansion connectors (Memory Interface, Peripheral Interface and Host Port Interface)
	On board IEEE 1149.1 JTAG connection for optional emulator debug
	Four 3.5 mm audio jacks (microphone, line-in, speaker and line out)
	4 user definable LEDs
	4 position dip switch, user definable
	+5 Volt operation only, power supply included
	Si ze : 8. 25" x 4. 5" ( 210 x 115 mm) , 0. 062" t hi ck, 6 layers
	Compatible with Spectrum Digital’s DSK Wire Wrap Prototype Card

 

 

SOFTWARE FEATURES:
	TMS320C6713 DSK specific Code Composer Studio from Tex as Instruments
	Test / sample code provided to reduce coding time
	NOTE : We can also provide other imported DSKS.

 

 

ALS-SDA-320C50 DSP TRAINER KIT
CPU	TMS 320C50 Fixed point DSP.
SPEED	50ns single cycle fixed point instruction execution time (20 MIPS).
MEMORY	EPROM 2KB on-chip ROM with boot loader 32K X 8 EPROM Debugger software .
RAM	9K on-chip SARAM (DATA + PROGRAM), user software area.
I/O SERIAL	0ne RS232 compatible interface.
ANALOG	Voice quality data acquisition via INTERFACE TLC32040. EP sockets are provided for direct connection to microphone and speaker
XDS510 JTAG	Emulation pins of the DSP are terminated in a standard 14 pin header
POWER SUPPLY	Built-in power supply

 

DSP-C50-OPT 01 CODEC INTERFACE TO 320C50 TRAINER (CODEC-HD44233)
FEATURES:
	Single chip CMOS CODEC with filter in 16-pin DIL package. Follows A-law Companding
	Synchronous / Asynchronous operation for 2048 / 1544 / 1536KHz. PCM rate
	Anti-Aliasing Filter (2nd Order CR active filter)
	Input Amplifier
	Power supply Voltage +/- 5V, Low Power Dissipation (50mW Typ)
	Auto-Zero cancel circuit without external component
	Sampling rate is 8 KHZ.
	INPUT - Audio Input through RCA jack
	OUTPUT - Audio output to speaker through RCA jack
	COMPANDING A law Companding
	INTERFACE PORT - 320C50 TDM serial port
	CLOCK - The basic system clock 4MHz is provided from timer output of DSP 320C50 trainer

 

Note :
	The unit works only on Windows 95/98
	Optional 'C' Complier